– 78 –
Setting the Time Data
Setting the User Bit
Setting the user bit allows up to 8 digits of hexadecimal data such as memos (date, time), etc. to
be recorded in the sub code track.
1
Set the DISPLAY switch to UB.
2
Set the TCG switch to SET.
3
Select the UB MODE on the FUNCTION 3/5 page of the setting menu.
4
Set the user bit using the SHIFT/ITEM, UP and DOWN buttons.
SHIFT/ITEM button: This is used to cause the digit which is to be set to flash. Each time it
is pressed, the flashing digit moves to the right.
UP/DOWN buttons: These increment/decrement by 1 the figure of the flashing digit.
The hexadecimal characters A to F appear as follows.
5
Set the F-RUN/R-RUN switch to F-RUN or R-RUN.
User bit memory function
The user bit setting (except for the real time) is automatically stored in the memory and held
even after the power is turned off. However, care should be taken as the settings are not stored
in the memory if the time from when the power was turned on until the setting operations are
completed and the power is turned off is less than 20 seconds.
<Notes>
¡
When REAL has been selected for UB MODE, the values set for HOUR and MINUTE on the
TIME/DATE page apply.
¡
If REAL has been selected for UB MODE and the DISPLAY switch is set to UB, the LCD dis-
play is held when the menu switch is set to SET.
Hexadecimal
A
B
C
D
E
F
Display
2,5
1
4
