- 62 -
≥
Select the [FOCUS TRANSITION] menu.
≥
Register [FOCUS TRANS] to a USER button. (
)
1
Switch to Manual Focus Mode. (
)
2
Press the USER button to which [
FOCUS TRANS
] is registered or touch the
applicable USER button icon.
3
Touch a registered item ([1]
s
[3]).
≥
Focus Transition will start. Focus will shift slowly from the
current position to the registered position. This will take a
few seconds. (
≥
As the focus shifts, the Focus Transition bar will move
from [S] to [E].
4
Touch [EXIT] to exit Focus Transition.
≥
If you move this unit a lot after setting the focus position, focus may not stop at the set position.
≥
When Focus Transition is in use, focus cannot be adjusted with the focus ring.
≥
Focus Transition is not available in the following cases:
j
When Auto Focus is used
j
During Freeze Frame (
j
During Super Slow Recording (
)
j
In Variable Frame Rate Mode (
j
When color bars are displayed. (
j
When a remote control (commercially-available) is connected (
j
During AG ROP application connection (
)
≥
Focus Transition settings are canceled in the following cases. To use Focus Transition again,
register a focus position again. (
j
If you turn the unit off
j
If you press the THUMBNAIL button
j
If you operate the zoom
j
If you enable or disable Infrared Recording Mode
≥
When Focus Transition is in use, only the USER button functions below are available. Press the
applicable USER button (one of the USER buttons 5 to 9 button) to use them. (
j
[FOCUS ASSIST 1]
j
[FOCUS ASSIST 2]
j
[FOCUS TRANS]
j
[IR REC]
j
[BACKGROUND]
j
[PRE-REC]
j
[USB MODE]
j
[EVF ON/OFF]
j
[AUTO REC]
j
[MENU]
≥
You can switch between the items or exit Focus Transition by pressing the USER buttons 1
s
4.
≥
When using Focus Transition, functions registered to the USER buttons 1
s
4 do not work with the USER buttons.
Using Focus Transition
A
[EXIT]
B
Focus Transition bar
S
E
1
2
3
MF50
MF50
MF50
USER button
Corresponding setting
USER1 to USER3
[1] to [3]
USER4
[EXIT]
AG-UX180ED(DVQP1171ZA)_E.book 62 ページ 2016年11月28日 月曜日 午前11時32分