68
Screen displays (continued)
16 Remaining media memory displays
The amount of memory remaining on the
card in the slot targeted for recording is
displayed when “ONE CARD” is selected
as the “P2 CARD REMAIN” item setting on
the setting menu “DISPLAY SETUP” screen.
The target slot can be switched to another
slot using “SLOT SEL” assigned to [USER].
When “TOTAL” is selected, the total amount
of memory remaining on the two cards is
displayed.
17 Media information displays
The card slots in which P2 cards have been
inserted and the basic information on the cards
are displayed.
1 2
Lighted:
Recordable P2 card
1 2
Lighted in green:
P2 card targeted for recording
1 2
Blinking:
Card recognition underway
:
No card inserted
P :
Write-protected card
F :
No memory remaining
X :
Card cannot be recognized
E :
Improperly formatted P2 card (which can be
used if it is formatted properly)
18 Monitor volume level meter
When
is pressed, the level of the
volume which is output from the speaker and
headphone jack is displayed.
You can adjust the volume level using the
and buttons.
Warning displays
LOW BATTERY
No operation is possible because the battery
charge is depleted.
INCOMPATIBLE CARD
The card complies with the different standard and
so it cannot be used.
COPY INHIBITED
The input signals are copy-guarded so they
cannot be recorded correctly.
DIR ENTRY NG CARD
The card contains folders which are organized
illegally. A warning will be displayed when this
P2 card is inserted into a P2 device or when
recording has ended.
RUN DOWN CARD
The P2 card has reached the end of its service
life. It is recommended that you replace it. Even
when a warning appears, it can still be used for
recording or playback. However, a warning will
be displayed when this P2 card is inserted into a
P2 device or when recording has ended.
FORMAT ERR !
The card does not comply with the P2 standard.
< Thumbnail screen>
CANNOT ACCESS!
Data cannot be accessed because of a problem
in the content or for some other reason. Restore
the media or clips to the normal operating status,
and then use the data.
WRITE PROTECTED!
The P2 or SD card is write-protected. Insert a
media on which data can be saved.
NO CARD!
The P2 or SD card has not been inserted. Insert
a media which is supported.
CARD FULL!
There is no more free memory on the P2 or SD
card. Insert a media with free memory.
CANNOT DELETE!
Data cannot be deleted because of a mismatch
in the content versions. Ensure that the same
content version as the device is used.
CANNOT FORMAT!
The P2 card cannot be formatted because of a
problem. Check the P2 card.
CANNOT REPAIR!
The content does not need to be repaired
because there is nothing wrong with it or because
of a similar reason. Check the selected content.
CANNOT RE-CONNECT!
Clips cannot be reconnected because content
which is contained on no more than one card has
been selected or because of a similar reason.
Check the selected content.
NO COPY TO SAME CARD!
Data cannot be copied because the same card
is being specified for the copy source and copy
destination. Copy the data onto a card which
does not contain the selected clip.
TOO MANY CLIPS!
Too many clips have been selected. Reduce the
number of clips which have been selected.
