4
PRIMUSBUSINESS.CA
PRIMUS BUSINESS SERVICES
|
HOSTED PBX
|
PANASONIC A406 REPEATER QUICK SETUP
GUIDE
Registering the Repeater to Another Repeater
A repeater can be connected to another repeater in series to extend total coverage
to up to 150m. This can be done by registering the repeater to another repeater.
In the diagram above, the destination repeater is registered with the base unit, and
the origin repeater is connected in series to the destination repeater.
This section
describes how to set up the origin repeater. Before you begin, you must
register the destination repeater to the TGP600 base unit. Please follow the
steps in the previous section on how to register a repeater to the base unit.
To register a repeater to another repeater, they must be set to the same ID.
On the destination repeater:
1.
First check the ID of the repeater you are attempting to register to
(destination repeater). With the destination repeater turned on and
functioning normally, press the
PROGRAM
button located under the
destination repeater. Note the number of times the
indicator flashes
green. This is the ID of the destination repeater – one flash indicates the ID
as 1, two flashes indicate the ID as 2, and so on.
2.
Return the destination repeater back to normal operation by pressing the
PROGRAM
button again. Both the
and
STATUS
indicators should go
back to
solid green
.
On the origin repeater:
3.
Turn on the repeater you want to register (origin repeater) by connecting the
AC adaptor. The
STATUS
indicator should be
flashing red
and the
indicator should be off.
4.
On the origin repeater, press and hold the
PROGRAM
button for 5 seconds
until the
STATUS
indicator
flashes green
. Release the
PROGRAM
button.
(Destination
Repeater)
(Origin
Repeater)
