Panasonic 932CR-BT4509, Руководство по эксплуатации

Страница: 23 / 44

23
Notes :
¡
We shall not guarantee all the functions of the
Bluetooth ® device to be connected. When opera-
tions cannot be performed via this unit, operate
the system via the Bluetooth
® device.
¡
Be aware that the battery of a Bluetooth
®
device
drains faster if the Bluetooth ® device is con-
nected to this unit.
¡
Even when the Bluetooth ® device that is con-
nected to this unit is located near this unit,
sound may be interrupted or noise may be
generated.
¡
The Bluetooth ® device with over 5-digit PIN code
is not operated with this unit.
¡ “B/T DISCOND is displayed when the Bluetooth ®
device is disconnected.
Setting of PIN (Personal Identity Number) code
1
Hold down
[6]
for more than 2 seconds
to call the PIN code entry mode.
2
Press [6] to prepare for adjustment.
1st digit blinks
3
Enter a number for each digit.
[
s
]
/
[
d
] : Selects number (0 – 9).
[6] : Selects next digit to be entered.
Digit entered
4
Press [6] to determine the PIN code
entry when last digit is entered.
Completed
Note : To check the Bluetooth ® address of this head
unit, press [SEL] after step 1 .
Connection of the registered
Bluetooth
®
device to this unit
1
Press the preset button(s) [1] through
[6] to select the registration number of
the Bluetooth ® device of interest. (Refer
to the above.)
2
Hold down [BAND] for more than 2
seconds for connection.
The Bluetooth
®
indicator ( ) lights.
Notes :
¡ Even if [SRC] (Source) is pressed to change the
source, the connection stays connected.
¡
Depending on the communication status, it may
takes 5 to 40 seconds for device connection.
Disconnection of the Bluetooth
®
device
Hold down [BAND] for more than 2 seconds.
The Bluetooth
®
indicator ( ) turns off.
Note : When the Bluetooth ® device is out of reception
range or encounter serious interference by outer
signal, “ERROR” appears and this unit will automati-
cally disconnect the connections.
Deletion of the registered data
1
Press the preset button(s) [1] through
[6] to select a registration number as-
signed to the Bluetooth ® device whose
data is to be deleted. (Refer to the
above.)
2
Hold down the preset button
[1]
through [5] selected above for the
registration number for more than 2
seconds.
3
Press the preset button that was
pressed at the step above again.
4
Push [SEL] .
Deletion completed