1
3
4
5
INSTALL THE LENS RETAINER.
Remove the two front
assembly screws and remove the retainer. Adjust the projector
lens shift to
center the projector lens.
vertically and horizontally
Squeeze the retainer and work it into the projector opening to
nest into the inside rim of the projector housing with
prongs toward
the ceiling
top ridge aligned with the projector top-front
and the
rib
. Tighten the three retainer screws just enough to lock.
PREPARE THE PROJECTOR.
Adjust the projector roll, tilt
and/or yaw so the projector test pattern lines are square to the
screen edges. Adjust the vertical lens shift so the test pattern is
centered on the screen. Now
instead of
show a 2.4:1 movie
the test pattern. Set the Sony anamorphic lens menu setting to
1.32x
and set the Sony Aspect button on the remote to
.
V-Stretch
INSTALL THE CDR LENS.
After removing the rear CDR lens
cover, install the CDR lens/mount assembly over the retainer
prongs. Insert and tighten the two assembly screws to secure
(
).
do not over tighten
Remove the front protective film.
ADJUST THE LENS TILT AND PROJECTOR SHIFT.
Adjust
the projector lens zoom to fill the width of the screen with the
2.4:1 movie. Tilt the CDR lens and adjust the projector vertical
lens shift to make sure the beam is getting through the CDR
lens to fill the screen. There is only a slight variation in vertical image
height with this adjustment but experimentation may lead to the best
image fit and geometry. Lock the CDR lens tilt by tightening the single
Phillips tilt lock screw (
).
do not over tighten
DECIDE HOW TO WATCH 16:9 CONTENT
(including menus).
Use the Sony “Aspect” button on the remote to select
Squeeze
to watch 16:9 content in the center of the screen or select
Normal
to stretch 16:9 content to fill the entire screen width.
CDR-S3 Installation Steps
Assembly
Screws
Tilt Lock
Screw
Projector
Zoom and Focus
Top Ridge
Prongs to
Ceiling
www.panamorph.com
