Set Auto-Lock delay
10
seconds
seconds=00: off
seconds=10 ~ 99 : on
Default 10 secs
Set Buzzer volume
20
level
Level = 0 : off
Level = 1~3 : on,
low/medium/high
Default 2
Set Lock out params
40
41
40: turn off the lockout
41: turn on lockout (default is
on)
○ To operate all the above settings need the lock to be unlocked.
○
The lock exit the setting mode when the settings have changed.
○ Auto-lock is suspended In the Keypad Programming mode, and it will restart
when quitting the mode.
○ If lasts over 10 seconds between the code input, the setting has to restart.
○ Press
button to quit the Keypad Programming mode.
○ The lock will exit the programming mode when an invalid input enters.
○ Exterior Lock UI:
■ A successful setting : green flash x 1 + long beep x 1
■ Cancel, Timeout, Error or Fail : (red flash + beep) x 2
Reset the lock
● After a long press on the reset button for 5 seconds with a long beep, the lock will do
the latch position recognition and end up the lockbolt extend.
● If reset success, the lock returns to factory default and enters the Keypad
Programming Mode, If the reset fails, please reset it again. Please note that the
Bluetooth will be turned on with a successful reset, however, it will be turned off when
the keypad panel awakes. If the Stand-Alone Mode is needed, you can straightly pair
your smartphone to the lock when the reset is done.
● LINK Mode :
○ In this mode, the Owner and Family will receive a real-time alert if the lock is
reset.
○ After resetting the lock, the LINK disconnect with the lock.
.
Key Cover Open
● Open the key cover before access by the physical key.
● If key cover open lasts for 30 seconds, the exterior Led will keep flashing in red till the
key cover is closed.
● In Stand-Alone Mode :
○ An audit trail remains.
7
