To the TV via antenna cable (if you are not using a RCA cable)
If you are using a RCA cable, select the AV
input on the TV to see the picture from the
video
If you are not using a RCA cable, select the
button number on the TV reserved for video
input to see the picture from the video
If you are not using a RCA cable, your video can transmit pictures and sound to the TV via the
coax aerial cable. Just tune the TV to the video's output channel (factory set to UHF CH26)
Tune the TV carefully to ensure the best pictures and sound.
Once you have carried out the steps in
"Connecting up the video recorder" (page 4),
switch on your TV.
Press the OK button of the video's remote control
longer than 5 seconds to call the video's test
picture.
Tune the TV to the test picture using the channel
pre-set functions of your TV as described in its
manual.
When you have found the test picture, store it
under the button number on your TV for video
input.
Press the OK button of the video's remote control
again longer than 5 seconds to release the test
picture.
If the
quality of the test picture
transmitted to the TV is poor due to interference caused by
a station transmitting on channel 26. you can tune the video to a different transmitting
channel Find a free channel between 21 and 69 on your TV
Call the video's "MAIN MENU" choose
"VCR Setup" then "RF Output Set".
Type in the free channel.
Store and exit
If the quality of the test picture transmitted to the TV is poor, fine-tuning on the TV may
help (refer to the TV manual)
17
CONNECTIONS
a n d
c o p y i n g
