Palram Applications Harmony 6x8, Инструкция по эксплуатации

Страница: 4 / 87

During Assembly
Attention
• During assembly use a soft surface below the parts to avoid scratches and damages.
Steps
Step 6: Determines the front side of the greenhouse.
Steps 10, 16, 19:
The oval hole in the crossbars.
256
should always be assembled to the base of
the greenhouse.
Steps 12-13, 57:
In order to insert profile #
8378
in between two
#7310 & 7311
profiles, please
apply silicone lubricant.
Door assembly (Steps 14, 57-65)
Door can be installed as a left hand door or right hand door to your decision. These instructions
show a right hand door assembly.
Step 14 Door Assembly:
Determines door direction. Part
7311
is the side that the door hinges
will be located. The door can be installed either as a left or right hand door. These instructions
show a right hand door assembly.
When encountering the information icon, please refer to the relevant
assembly step for additional comments and assistance.
This icon indicates that
the installer should be
outside the product.
This icon indicates
that the installer should
be inside the product.
• Make sure the base is square by measuring the diagonals and level by using a spirit level.
• You may use silicone lubricant spray in order to help you slide the panels into the profiles.
• Do not spray the polycarbonate panels.
• Use a rubber mallet if necessary.
Steps 57-65:
Door assembly should be done according to this decision.
Window assembly (Steps 39, 56)
Step 39:
Decide on the window’s location before assembly. Window can be installed in one of
the indicated options.
Steps 39, 40:
Once the window location is chosen, please turn part
7316
into the correct
position accordingly.
Step 56:
If the window doesn’t close properly, please release the screws, adjust the profile
and re-tighten the screws.
* Please tighten all screws when completing assembly.
Note:
Firmly connect the product to a level surface immediately after completion of
the assembly.
Anchoring this product to the ground is essential to its stability and rigidity. It is
required to complete this stage in order for your warranty to be valid.
412
&
466
• Screws 411 and nuts 412 & 466 are used throughout the assembly process.
• Screws 411 are to be assembled from the outside and nuts 412 & 466 from the inside of
the greenhouse.
• If not specified otherwise, do not fasten screws and nuts (411, 412 & 466) more
than 2-3 turns only. Do not tighten them until completion of the panels’ assembly.
These 2 icons indicate if screws’ tightening is required or not.
• However, in some steps, temporary tightening of a few screws may be needed to
prevent a profile from falling.
EN