3
Robata Outdoor Burner Owner and Installation Manual
TO ASSEMBLE THE BURNER
1. Remove the Burner Assembly and Burner Media
from packaging (see Parts List on page 12).
2. Connect the Burner Assembly to the gas supply
using the supplied flex connector and following the
instructions on page 5.
3. Carefully leak test all connections following the
procedure on page 5.
4. Fill the burner trough evenly with burner media
(broken tempered glass).
Do not cover pilot cage
with glass media!
5. Place the burner assembly on a stable surface.
6. Follow the Initial Lighting Instructions on page 7.
Make sure that the flame is even along the burner
length and appliance is fully operational and safe
for use. Turn OFF the appliance and let it cool
before proceeding to the next step.
7. Carefully lift the burner and place it in its housing.
(See page 4)
8. Place and evenly distribute decorative topping media
(lava rock or broken tempered glass) on top of burner
media as shown in picture (if applicable).
Do not
cover or block the pilot cage!
WARNING:
Failure to position parts in
accordance with these diagrams
and instructions and/or failure to
use parts specifically approved for
use with this appliance may result in
property damage or personal injury.
CAUTION:
Do not remove the metal data
plates attached to the Outdoor Fire
Pit Burner. These plates contain
important information.
NOTICE:
Installation and repair should be
done by a qualified service person.
The appliance should be inspected
before use and at least once annually
by a qualified service person. More
frequent cleaning may be required
as necessary. It is imperative that
control compartment, burner and
circulating air passageways of the
appliance be kept clean.
BURNER ASSEMBLY
