6
MISO 48 FIREBOWL Electronic Ignition | Installation & Owner's Manual
ASSEMBLY
TO ASSEMBLE THE FIRE PIT
1. Connect the Burner Assembly to the gas/propane
supply using the supplied flex connector and following
the instructions on page 8.
2. Carefully leak test all connections following the
procedure on page 8.
3. Fill the burner pan evenly with burner media (crushed
tempered glass for natural gas; volcanic rock for
propane). Do not obstruct the pilot lighting port with
burner media! Use burner media supplied by Paloform
only!
4. Follow the Initial Lighting Instructions on page 9.
Make sure that the flame carries to all parts of the
burner. Turn OFF the appliance and let it cool before
proceeding to the next step.
5. Place Topping Ring. Evenly distribute decorative
topping (river stones, crushed glass or lava rock) on
top of burner media. An uneven or excessively thick
layer of topping can result in an uneven flame.
6. Do not cover pilot shield. Keep the lighting port open
and free of media. Do not use any media not supplied
by the manufacturer!
BURNER MEDIA
DECORATIVE TOPPING
IGNITION PORT:
DO NOT OBSTRUCT
CORRECT FLAME APPEARANCE
WARNING:
Failure to position parts in
accordance with these diagrams
and instructions and/or failure to
use parts specifically approved for
use with this appliance may result
in property damage or personal
injury.
Do not remove the data plates
attached to the Outdoor Fire Pit
Burner. These plates contain
important information.
NOTICE:
Installation and repair should
be done by a qualified service
person. The appliance should be
inspected before use and at least
once annually by a qualified service
person. More frequent cleaning
may be required as necessary.
It is imperative that control
compartment, burner ports and
circulating air passageways of the
appliance be kept clean.
CAUTION:
New Lava Rock may pop or crackle
when first heated. This should
subside after 30 minutes to one
hour or more of operation. Maintain
safe distance during this time.
