4
CALDERA E CORTEN FIRE PIT | Owner and Installation Manual
1. Please refer to ‘Clearances to Combustibles’ guide on page 6 of this guide for placement.
2. Ensure that the final location for the fire pit is as flat and level as possible. Also provide adequate drainage
beneath the fire pit.
3. Completely unpack the fire pit. Some components may be packed inside the Caldera body.
4. Note where the control knob hole is to ensure that it will face in the desired direction. Carefully lift the fire
pit and place it in its final position. If there is a gas riser, fire pit vessel should be placed so that the stub is
enclosed within the Caldera body (2).
5. If the Caldera does not sit level, shim appropriately so that it is level and evenly supported.
6. Use a blanket or other padding to protect fire pit from damage. Carefully tilt and lift fire pit so that it is resting
on its side. Make sure that the fire pit is secure and supported before proceeding.
7. Connect flex hose to Natural Gas or Propane Source as per page 8 of this manual. Check connections for
leaks. (see page 8)
8. Ensure that power supply to outlet is off. Connect power supply to burner and to outlet.
9. Carefully lower fire pit back into place.
10. Assemble and test burner as per instructions on page 7.
CAUTION:
HEAVY: Use care
when lifting and
placing to avoid
injury and damage
to property and the
fire pit itself. Fire pits
will require 2 or more
people to lift.
ATTENTION: Cor-Ten Steel is designed to rust in order to form a protective layer that resists further
corrosion. This layer can take months to stabilize depending on climate and weather conditions.
Rust will bleed until it stabilizes. Do not place Cor-Ten fire pits on surfaces that will be permanently
damaged or stained by rust bleed.
PLACEMENT AND ASSEMBLY
