PaloAlto Networks PA-5200 Seriesp, Справочник по аппаратуре

Страница: 41 / 60

Service the PA-5200 Series Firewall
STEP 9 | Different model replacement drive only) Add the replacement drive (that is a different model
than the failed drive) to the RAID 1 array:
When you iniate the copy command as described in the following steps, logging
stops and you cannot view logs unl the copy is complete and the disk pair shows
Available
.
1. (Oponal) Suspend the firewall with the failed drive if it is the acve firewall in an HA
configuraon.
The firewall will fail over when the copy process in this procedures starts but you
can choose to Verify Failover or manually suspend the firewall with the failed
drive before you connue.
2. Copy the data from the other drive in the RAID 1 array to the replacement drive. In this
example, run the following command to copy the data from the Log2 drive to the Log1
drive:
admin@PA-5020> request system raid copy from log2 to log1
3. Run the following CLI command to view the status of the copy:
admin@PA-5020> show system raid detail
Periodically run this command unl the copy is complete and the Disk Pair Log
shows Available .
At this point, the
Log2
drive shows
not in use
because the drive models are
not the same.
Disk Pair Log Available
Status clean, degraded
Disk id Log1 Present
model : ST2000NX0999
size : 1907729 MB
status : active sync
Disk id Log2 Present
model : ST2000NX0253
size : 1907729 MB
PA-5200 Series Next-Gen Firewall Hardware Reference 41
©
2021 Palo Alto Networks, Inc.