4
Palmgren Operating Manual & Parts List 9683127
ASSEMBLY (CONTINUED)
CENTERING THE TABLE
Refer to Figure 1.
1. Loosen the four hex bolts mounting the table to the upper table
trunnion.
2. Move the table sideways as required, until the saw blade runs
through the center of the table insert.
3. If moving the upper table trunnion is not enough to center the
table, loosen the four flange nuts holding the lower table
trunnion and move the table sideways to place the table in the
center.
4. Re-tighten hex bolts for trunnion and flange nuts, recheck the
saw blade position.
SETTING TABLE SQUARE TO SAW BLADE
Refer to Figures 2 and 3.
Loosen the knob on the lower table trunnion and place a suitably
sized square against the saw blade. If the table requires adjustment,
proceed as follows:
1. Using a wrench, release the hex nut on the bolt (see Figure 2).
Place the wrench on the hex bolt and adjust until the table is
square to the saw blade.
2. Tighten the hex nut and recheck the saw blade and the table for
squareness.
3. Lock the table into position and check that the indicator reads
zero degree on the side of lower table trunnion. Loosen the
screw securing the indicator and reset if necessary to give zero
degree reading (see Figure 3).
FASTEN GUIDE RAIL
Refer to Figure 4.
• Fasten the guide rail with four hex bolts and washers to the
table.
INSTALL RIP FENCE
Refer to Figure 5.
• Lay the rip fence onto the guide rail. Adjust the rip fence parallel
to the saw blade. Tighten rip fence handle by pressing
downward.
STABILIZE MACHINE
Refer to Figure 6.
• To ensure sufficient upright stability of the machine it should be
bolted to floor, bench or worktable. For this purpose 8mm holes
are provided in the machine’s base. Mounting hardware not
provided.
Figure 2 - Square table to saw blade.
Square
Hex Nut
Hex Bolt
Figure 3 - Set indicator to zero.
Figure 4 - Fasten guide rail.
Figure 5 - Install rip fence.
Figure 6- Mounting holes and dust port.
Dust Port
Mounting
Holes
