Palmera PAT 2040, Руководство пользователя, Страница: 21 / 25

TECHNICAL DATA
Power input
2000W
Voltage 230V
Power frequency 50Hz
No load speed 8100min
-1
Guide bar length 405mm
Weight
4.4Kg
Calculated LwA 106dB(A)
Vibration level
5.092m/s
2
Oil tank capacity 90ml
Notice:
- the declared vibration total value has been measured in accordance with a standard test
method and may be used for comparing one tool with another;
- the declared vibration total value may also be used in a preliminary assessment of
exposure.
Warning:
- the vibration emission during actual use of the power tool can differ form the declared
total value depending on the ways in which the tool is used”.
- avoid vibration risk, suggestion:
1) wear glove during operation;
2) limit operating time and shorten trigger time.
MAINTENANCE
The following suggestions deal with the daily maintenance of the chainsaw. In the event of
failure contact an authorised service centre.
●
Ensure that the electric power cord is not damaged.
●
Ensure that the motor and cooling slots are unobstructed.
●
If there is a reduction in motor power, the carbon brushes may need replacement.
● Check there is sufficient oil.
●
Clean the chain brake and ensure that it works properly.
●
Check the bar wears.
●
Ensure that oil-ways are unobstructed.
●
Clean the chain guide on the bar.
●
Check the chain tension, sharpen the blades and check their condition.
●
Check the guide bar sprocket.
● Ensure that the oil reservoir and the oil filter are clean.
This chainsaw meets all legislation requirements; in order to avoid injures all repairs are to
be done by qualified sta
ff in an authorized service centre.
CHAIN SHARPENING
It is highly recommended that, once the chain loses it’s ability to cut cleanly and safely, it is
replaced.
It is possible, however, to sharpen the existing chain if done carefully.
To sharpen the chain refer to Fig.11 below and proceed as follows:
GB10
SEMAK