Do not skip this instruction manual. Read the instruction manual carefully before using the
equipment. If failed in doing so it may cause serious injury or Death.
02
Palmer Safety | 6000 Jefferson Hwy | Harahan, LA 70123
This manual must be read and understood in its entirety and used as part of fall protection training program
as required by OSHA or any state regularity agency. These instructions are intended to meet the
manufacturer instructions as required by ANSI Z 359.11 and OSHA 1926. The user must fully understand
the proper equipment use and limitations.
1. GENERAL REQUIREMENTS, WARNINGS AND LIMITATIONS:
The Equipment is designed for use as a part of a personal fall protection system. Components must
not be used for any other operation other than that which it has been designed and approved. Fall
Arrest system are designed to comply with OSHA. Fall Restraint System must be designed by a
Qualified Person, and must be installed and used under the supervision of a competent person.
All authorized persons/users must refer the regulations governing occupational safety, as well as
applicable ANSI or CSA standards. Please refer to product labeling for information on specific
OSHA regulations, and ANSI and CSA standards met by product.
Consult a doctor if there is any reason to doubt a user's ability to withstand and safely absorb fall
arrest forces. Age, fitness, health conditions can seriously affect the worker a fall occur. Pregnant
Women and minors should not use this equipment.
Proper precautions should always be taken to remove any obstructions, debris, material, or other
recognized hazards from the work area that could cause injuries or interfere with the operation of
the system. All equipment must be inspected before each use according to the manufacturer's
instructions. All equipment should be inspected by a qualified person on a regular basis.
To minimize the potential for accidental disengagement, a competent person must ensure system
compatibility.
Equipment must not be altered in any way. Repairs must be performed only by the Manufacturer,
or persons or entities authorized in writing by the manufacturer.
Any product exhibiting deformities, unusual wear, or deterioration must be immediately
discarded. Any equipment subject to a fall must be removed from service. The authorized person/
user shall have a rescue plan and the means at hand to implement it when using this equipment.
Never use fall protection equipment for purposes other than those for which it was designed. Fall
protection equipment should never be used for towing or hoisting.
All synthetic material must be protected from slag, hot sparks, open flames, or other heat sources.
The use of heat resistant materials is recommended in these applications.
Never use natural materials (manila, cotton, etc.) as part of a fall protection system.
Do not expose this equipment to chemicals which may have a harmful effect on the materials used
to construct it. Be especially aware of caustic environment, or those that contain high levels of
organic acids or bases. If you are uncertain about the safe operation of this equipment in any
environment, contact Palmer Safety for further instructions.
Palmer Safety Full Body Harness should be used only with the combinations of components, sub-
systems or both which may affect or interfere with the safe function of one another. Be certain that
connecting devices are compatible and that other elements of the PFAS are safe to use and
compatible before use.
Lanyard Parking attachment is for parking unused leg of the lanyard and should not be used for
any other purpose. Refer product label for locating the lanyard parking attachment point.
