Pallmann
Cobra
II
Manual
32
Instructions:
Caution!
Before beginning with the following procedure, the main lifting lever must be pulled
back and engaged to ensure the sanding drum is away from the fl oor.
1. Turn motor to the off position and disconnect main power cord from motor.
2. Open the access door.
3. Insert a sanding belt.
4. Shift the tension lever backwards to place tension on the sanding belt.
5. Loosen the retaining nut (1)
6. Connect main power cord to motor (see chapter 7.7 and chapter 7.8)
7. Allow the machine to run in position “
Start
”.
8. By turning the adjusting nuts (2), you can move the tension roller to change the path
of the sanding belt. Adjust the position of the sanding belt until it runs in the middle
of the sanding drum.
9. Switch the machine off. Disconnect the main power cord from the motor.
10. Tighten the adjusting nuts (2). Tighten the retaining nut (1) securely.
11. Close the access door.
3
COBRA CLASSIC #74540
09/2014
Contents
1
Introduction .....................................................................................................................................................................
4
2
Scope of delivery ............................................................................................................................................................
5
3
Machine specifications COBRA CLASSIC ...................................................................................................................
6
3.1
Important components ......................................................................................................................................................
6
3.2
Technical data ..................................................................................................................................................................
7
3.3
Safety and machine protection facilities............................................................................................................................
7
4
Proper use .......................................................................................................................................................................
7
5
Assembly of the machine...............................................................................................................................................
8
5.1
Installing the guide tube ...................................................................................................................................................
8
5.2
Installing the motor ...........................................................................................................................................................
8
6
Disassembling for transport .........................................................................................................................................
9
6.1
Removing the guide tube ................................................................................................................................................
9
6.2
Removing the motor..........................................................................................................................................................
10
7
Operating the COBRA CLASSIC ..................................................................................................................................
11
7.1
Protective clothing and equipment ..................................................................................................................................
11
7.2
Fitting the dust bag ........................................................................................................................................................
11
7.3
Safety instructions regarding dust ....................................................................................................................................
12
7.4
Disposing of sanding dust ...............................................................................................................................................
12
7.5
Replacing the sanding belt ..............................................................................................................................................
13
7.6
Adjusting the sanding pressure .......................................................................................................................................
14
7.7
Safety instructions for electric cable and connectors ......................................................................................................
14
7.8
Connecting the COBRA CLASSIC to the mains power ..................................................................................................
15
7.9
Remarks about sanding parquet and plank floors ..........................................................................................................
16
7.10
Sanding with the COBRA CLASSIC ...............................................................................................................................
19
8
Maintenance ...................................................................................................................................................................
24
8.1
Changing the sanding drum ............................................................................................................................................
24
8.2
Adjusting the running wheels ..........................................................................................................................................
26
8.3
Adjusting the castor wheels ............................................................................................................................................
27
8.4
Adjusting the tension roller ...............................................................................................................................................
28
8.5
Changing the belt ..............................................................................................................................................................
29
8.6
Checking dust extraction .................................................................................................................................................
30
8.7
Switching off and storing the machine ............................................................................................................................
30
9
Declaration of conformity ..............................................................................................................................................
31
10
Warranty...........................................................................................................................................................................
32