Pall DU005-US, Руководство оператора

Страница: 11 / 21

Document #: 4100022 Revision: F Page #: 11 of 21
6. DOLLY - TANK ASSEMBLY
Note : Certain larger tanks (>350L) are constructed in two parts.
7.1. The Dolly has a pre-cut hole over the drive port. Insert the Interface into this hole
from below and apply the O-ring as shown ( see
Figure 2
) to secure. It is not
necessary to remove or replace the Interface after mixing or between batches.
7.2 Position the plastic tank on the dolly. The bottom surface of the tank has two pre-
cut holes: a small hole for the bag drain and a larger hole for the drive head. Line
up the larger hole with the hole in the dolly over the drive port. The larger whole
should fit loosely around the Interface.