3. Press the
Timer Selector
button. The Timer Mode Lamp will light and the
display will read “000”.
4. Press and
hold
the
Program
button to display the current Timer setting.
Decrease time (minutes) using the
Decrease
button while simultaneously
holding the
Program
button until “000” minute is reached. Release buttons.
Timer is now adjusted for continuous operation.
5. Press
Start/Stop
button to start shaking continually. Press
Start/Stop
button to
stop shaking once samples are thoroughly agitated.
5
Starting Up:
1. Plug shaker into 115V 50/60 Hz or 230 V 50/60 Hz line as indicated on the
characteristics plate located on the back of the instrument.
2. Turn on the main rocker switch located on the back of the instrument. Follow
steps outlined below for Continuous Operation or Timed Operation.
Continuous Operation Example:
To run shaker in continuous (non-timed) operation, the timer must be set to “
000
”
minutes.
If, for example, the desired shaking speed is 200 undulations (cycles) per minute
(U/min.) for an undefined interval, follow the steps outlined below:
1. Press the
Speed Selector
button. The Speed Mode Lamp will light and the
display will read “000”.
2. Press and
hold
the
Program
button to display the current speed setting. Adjust
speed using the
Increase
or
Decrease
buttons while simultaneously holding the
Program
button until 200 is reached. Release buttons. Speed is now adjusted
to desired setting.
4
Instructions for Use
(continued)
Instructions for Use
(continued)
U/min
ST
AR
T
STOP
U/min
ST
AR
T
STOP
U/min
ST
AR
T
STOP
U/min
ST
AR
T
STOP
1240_87333C.qxd:1240_87333C.qxd 7/23/08 5:31 PM Page 7
