Palfinger MBB C 500 VAN, Руководство по эксплуатации

Страница: 147 / 196

147
To change the hydraulic oil:
 Lower the tail lift so that the platform touches the ground
(see chapter “Operating Elements” from p. 42).
 For the slide-in unit:
Draw out the hydraulic unit so that the valve block (51) is
positioned outside the block (see chapter “Checking the Oil
Level” from p. 141).
For the box-type, universal or reversible unit:
Remove the cover from the unit.
 Place a sufficiently large vessel under the oil drain
plug
(47) .
 Loosen the oil drain plug (47) using a 6 mm hex socket
wrench and drain the oil into the vessel.
If the hydraulic oil is extremely contaminated you must clean
the hydraulic oil reservoir
(48) :
 Loosen the clamp between the hydraulic oil reservoir (48)
and the valve block (51) .
 Drain the oil.
 Pull off the hydraulic oil reservoir (48) from the unit and
clean it outside the hydraulic unit.
 Also renew the suction filter in the oil reservoir (49) and the
breather filter (50) .
 Install the cleaned hydraulic oil reservoir into the unit and
reinstall the oil drain plug
(47) .
 Fill oil according to the marking at the oil reservoir or dip
stick.
Note: Exclusively use oils listed in the chapter “Lubricants and
Operating Media” from p. 188.
 After filling the oil reservoir, run the equipment through two
full working cycles.
 Check the oil level (see chapter “Checking the Oil Level”
from p. 141) and refill or drain oil as required.
 For the slide-in unit:
Push the hydraulic unit back into the support tube and fas-
ten it.
For the box-type, universal or reversible unit:
Re-install the cover of the unit.
 Dispose of the waste oil according the regulations.
47
Betriebsanleitung_Hubladebuehnen_EN.book Seite 147 Donnerstag, 15. August 2019 4:04 16