
MULTIFIRE 45 IDRO
cod. 004770072 - 05/2009
51/104
GB
D
7.3.2.2 Wood ignition (Automatic)
Operations to perform:
1) Open the door;
2) Lower the grille and rest it on the circular hearth;
3) Place small pieces of wood on the grille;
4) Close the door again;
5) Hold down the button
Menu/On
for at least 3
seconds.
The display will show the selection menu
AUTOMATIC
START “Wood Pellets”
(Fig. 7.3.3)
6) Choose wood start-up by pressing button “”.
The message “
START-UP”
will appear on the display
and the time left for the ignition time to finish alongside
(Fig. 7.3.5).
This phase (which lasts about fifteen minutes) is
automatic and completely managed by the fireplace.
Therefore, any modifications made will take effect only
when it is complete.
)
It is however possible to make an immediate
changeover of fuel, without waiting for the end of
START-UP
phase by pressing the
Off
button for at least
three seconds. A multiple choice menu will appear (Fig.
7.5.6). Within twenty seconds, press the key “
” to
go directly to
WOOD
status, otherwise the fireplace will
revert to the start-up phase.
7.3.2.3 Wood ignition (Manual)
Operations to perform:
1) Open the door;
2) Lower the grille and rest it on the circular hearth;
3) Place small pieces of wood on the grille and light;
4) Close the door again;
5) Adjust the flow of primary air to the maximum by
turning the knob (Fig. 7.4.9) clockwise as far as it
will go;
DANGER
Never use alcohol, petrol, kerosene or other liquid
fuels to light the fire.
Keep these substances far away from the fire. Do
not use petroleum or chemical based products to
light the fire.
Only use ecological fire lighting aids.
6) Hold down the
Off
button for at least 3 seconds to
access the menu (Fig. 7.3.6) where it is possible
to choose (by pressing key ”
”) the
WOOD
status display.
If this operation is is not performed, the display will
continue to show
OFF
until the fireplace reaches the
pre-set value for automatic changeover to
WOOD
status.
7.3.2.2 Zündung mit Holz (automatisch)
Zu ergreifende Massnahmen:
1) Die Tür öffnen.;
2) Das Gitter senken und auf die kreisrunde
Brennstelle auflegen;
3) Klein gehacktes Holz auf das Gitter legen;
4) Die Tür schliessen;
5) Die Taste
Menü/On
für mindestens 3 Sekunden
gedrückt halten.
Auf dem Display erscheint das Wahlmenü
AUTOMATISCHER START “Pellets Holz”
(Abb. 7.3.3)
6) Den Start mit Holz ählen, hierzu die Taste “”
drücken.
Auf dem Display erscheint die Schrift “
START
” und
daneben die restliche Zeit bis zum Abschluss der
Zündphase (Abb. 7.3.5).
Diese Phase (etwa 15 Minuten) ist automatisch und
wird vollkommen vom Heizkamin gesteuert, deshalb
sind geänderte Parameter erst nach ihrem Ablauf aktiv.
)
Es kann in jedem Fall ein sofortiger Wechsel des
Brennstoffs vorgenommen werden, ohne die Phase
START
abzuwarten, in dem man für mindestens drei
Sekunden die Taste
Off
drückt. Es erscheint ein Menü
mit mehrfachen Wahlmöglichkeiten (Abb. 7.5.6). Drückt
man innerhalb 20 Sekunden die Taste “
”, gelangt
man direkt in den Zustand
HOLZ
, andernfalls geht der
Heizkamin zur Startphase zurück.
7.3.2.3 Zündung mit Holz (manuell)
Zu ergreifende Massnahmen:
1) Die Tür öffnen.;
2) Das Gitter senken und auf die kreisrunde
Brennstelle auflegen;
3) Klein gehacktes Holz auf das Gitter legen und
anzünden;
4) Die Tür schliessen;
5) Durch Drehen des Knopfes im Uhrzeigersinn bis
zum Anschlag, die Zufuhr der Primärluft auf
Maximum stellen (Abb. 7.4.9);
GEFAHR
Zum Entzünden des Feuers niemals Alkohol,
Benzin, Kerosen oder andere flüssige Brennstoffe
verwenden.
Diese Stoffe sind fern von offenen Flammen
aufzubewahren. Keine Zündwürfel aus Petroleum
oder chemischen Ursprungs verwenden.
Ausschließlich umweltfreundliche Zündstoffe
verwenden.
6) Wird die Taste
Off
für mindestens 3 Sekunden
gedrückt, gelangt man in das Menü der (Abb.
7.3.6), in dem die Anzeige des Zustandes
HOLZ
gewählt werden kann (durch Drücken der Taste
“
”).
Wird dieser Vorgang nicht durchgeführt, zeigt das
Display weiterhin den Zustand
AUS
bis der Heizkamin
die festgelegte Temperatur für den automatischen
Übergang in den Zustand
HOLZ
erreicht hat.