27
- 5.2 -
- 5.3 -
Z
B
A
X
X
β
90°
c
a
ENGLISH
5.3
FLUES AND CHIMNEY CAPS
The chimney must be dimensioned in compliance with
EN 13384-1.
Follow the indications in the technical data sheet relating
to the chimney draught.
The flue pipe for the discharge of smoke must be
compliant with standards EN 10683, EN 1856-1-2, EN
1857, EN 1443, EN 13384-1-3, EN 12391-1,
EN15287-1
both in terms of size and materials used to construct it.
7KHVRRW¿UHUHVLVWDQFHFODVVRIWKHFKLPQH\PXVW
be at least T400.
A PERFECT DRAUGHT is above all the result
of a flue that is clear of obstructions such as
chokes, horizontal sections or corners; any axial
displacements should be at a maximum angle of
FRPSDUHGWRWKHYHUWLFDOD[LVEHWWHUVWLOOLILWLV
only 30°). These displacements should preferably
be effected near the chimney top.
THE SMOKE PIPE between the fireplace and
WKH ÀXH SLSH PXVW KDYH WKH VDPH FURVVVHFWLRQ
as the appliance’s smoke outlet. The smoke pipe
must be sealed. It is prohibited to use extendable
ÀH[LEOHPHWDOSLSHV7RFRQQHFWWKHDSSOLDQFHWRWKH
chimney, you may perform a maximum of 3 direction
changes no greater than 90°, with the smoke pipe
no longer than 2 m in horizontal projection and a
PD[LPXPRIWRWDOPHWHUV0DNHVXUHWKDWWKH¿UVW
vertical segment is at least 50 cm before changing
direction.
The CHIMNEY TOP shall be the WINDPROOF type
with an inside cross section equivalent to that of the
ÀXHDQGZLWKDVPRNHRXWOHWSDVVDJHVHFWLRQDWOHDVW
'28%/(WKHLQWHUQDORQHRIWKHÀXH
%DFNÀRZ DUHD 7KH RXWOHW PXVW EH RXWVLGH RI WKH
EDFNÀRZ DUHD FDOFXODWHG DFFRUGLQJ WR ¿JXUH
and relative table. Near the ridge cap, consider the
less of the two.
,IWKHUHDUHREVWDFOHVRQÀDWURRIVWRSRVLWLRQWKH
chimney respect the distances and measurements
DFFRUGLQJWR¿JXUHDQGUHODWLYHWDEOH
,I WKH ¿UHSODFH LV LQVWDOOHG ZLWK D ÀXH WKDW KDV DOUHDG\
been used it should be cleaned thoroughly to avoid
malfunctions and the danger of unburned parts deposited
RQWKHLQVLGHIURPFDWFKLQJ¿UH8QGHUQRUPDOFRQGLWLRQV
RIXVHRIWKHDSSOLDQFHWKHÀXHVKRXOGEHFOHDQHGDWOHDVW
once a year.
Symbol Description
Buffer zone
(mm)
c
Distance measured 90° from
the roof surface
1300
a
Height above the roof ridge
cap
500
Distance (mm)
Outlet position
;
Z + A
X > 2000
B
where A=500 and B=1000
