Palax C900.2, Инструкция по эксплуатации, Страница: 2 / 38

2 1-2020
Translation
CONTENTS
1.1 Foreword ............................................................................................................................... 4
1.2 EU Declaration of Conformity ............................................................................................. 5
1.3 Intended use of the machine ................................................................................................... 6
1.4 Warning signs ......................................................................................................................... 6
1.5 Nameplates ........................................................................................................................... 8
1.6 The main dimensions and models of the machine ......................................................... 9
1.7 Safety instructions ................................................................................................................ 9
1.8 Noise emission and vibration ........................................................................................... 10
1.9 Responsibilities of the operator ....................................................................................... 10
1.10 Operating conditions ...................................................................................................... 11
1.11 Terms of warranty ........................................................................................................... 11
1.12 Operating instructions for the winch ............................................................................ 11
2 Taking delivery and setting up the machine for operation .......................................... 12
2.1 Lifting the machine ............................................................................................................. 12
2.2 The transport set-up and unpacking ............................................................................... 12
2.3 Acceptance inspection ...................................................................................................... 12
2.4 Main parts of the machine, Fig 1 ..................................................................................... 12
2.5 Bringing the table extension into the work position, Fig. 2 .......................................... 13
2.6 Bringing the conveyor into the work position, Figs. 3 and 4 ........................................ 13
2.7 Bringing the conveyor into the work position, Fig. 5 ..................................................... 14
2.8 Adjusting the cutting length, Fig. 6 .................................................................................. 15
3 Operation of the firewood processor powered by different power sources ............. 15
3.1 Testing the machine .......................................................................................................... 15
3.2 Powered by a tractor ......................................................................................................... 15
3.3 Suitable revolutions range for the PTO shaft ................................................................ 16
3.4 Disengagement lever for transmission, Fig. 7 ............................................................... 16
3.5 Required measures in an emergency situation ............................................................. 16
3.6 Starting under cold conditions (machine powered by a tractor) ................................. 17
3.7 Electric drive, start and emergency stop. ....................................................................... 17
3.8 Starting the electric motor using the Y/D starter, Fig. 8 ............................................... 17
3.9 Emergency stopping of an electrically powered machine, Fig. 8 ............................. 18
3.10 The machine is equipped with a system to prevent simultaneous operation in two
modes, Fig. 9 ................................................................................................................................ 18
3.11 Operation under cold conditions .................................................................................. 19
3.12 Electric heater for oil tank .............................................................................................. 19
4 Full-hydraulic control ......................................................................................................... 20
4.1 Mastering the safety devices ............................................................................................ 20
4.2 Joystick-valve, Fig. 10 ....................................................................................................... 20
4.3 Other hydraulic operating controls, Fig. 11 .................................................................... 20
5 Use of the firewood processor, crosscut operation ..................................................... 23
5.1 Operating the crosscut saw, before the operation ........................................................ 23
5.2 During the operation .......................................................................................................... 23