13
51-4180
INSTALLATION
INSTALLATION
Install the mounting assembly to the swing assembly according to the instructions
included with the mounting kit for you application.
WARNING! To avoid personal injury, make sure mounting/swing assembly is securely
latched to the attachment mechanism of your unit. Failure to do so could
result in separation of the attachment from the prime mover.
1.
Position the brush head assembly in front of the mounting/swing assembly.
2.
Attach the brush head assembly to the front of the swing plate with the two .50” carriage
bolts, flat washers, lock washers and nuts.
3.
Install the spring-chain assembly by following the instructions that apply to your
mounting/swing assembly.
11-17174 SWING ASSEMBLY (SEE FIGURE #1)
1.
Connect a spring to each end of one 26-link chain.
2.
Connect the ends of the remaining 26-link chain to the other ends of the springs.
3.
Loop one of the 26-link chains through the bracket on the mounting frame.
4.
Loop the other end of the spring-chain assembly over the outside slots on the brush
head upright.
5.
Transport Chain:
Install the 36-link transport chain by placing one end in the center slot
of the brush head upright and the other end on the mounting frame bracket.
Transport Cable:
Install cable through the center hole in the brush head upright. Loop
the loose end around and secure it with a cable clamp. Attach the other end of the cable
to the lift actuator system. (if the mounting assembly includes a welded link, thread the
cable through the link before attaching to the lift actuator.)
6.
Refer to “LEVELING”
FIGURE #1
BRUSH
HEAD
UPRIGHT
TRANSPORT
CHAIN
SPRING/CHAIN
ASSEMBLY
