150-231-181-01, Revision 01
Provisioning
HLU-231 List 8A
September 7, 1999
11
P
ROVISIONING
This is a reference section for HLU provisioning. There are two methods for provisioning the HLU-231 List 8A:
•
Use the MODE and SEL buttons on the front panel of the HLU to:
–
set system options
–
reset the HLU to its factory default settings for system options
–
display system option settings (scroll mode)
–
select system loopbacks
•
Use a maintenance terminal (ASCII terminal or a PC running terminal emulation software) connected to the
HLU craft port to access the Maintenance Terminal Main Menu (
). This gives you full
access to all HLU status, history, inventory, and provisioning screens.
U
SING
THE
MODE
AND
SEL B
UTTONS
Setting Options through MODE and SEL
To provision the HLU-231 List 8A through the MODE and SEL buttons on the front panel:
1
Press the MODE button for 2 seconds and then release it. The front-panel display alternately shows the first
system parameter and its current setting.
2
Press the SEL button to step through all possible settings (one at a time) of the selected parameter.
3
After the desired setting has been selected, press the MODE button. This updates the current displayed
parameter to the selected setting, and then advances to the next configurable parameter. After the last
parameter has been selected, a
CONF NO
message appears on the front-panel display.
4
Do one of the following:
•
To cancel the session without saving the requested parameter changes, press the MODE button, or do
nothing. (After 30 seconds, the display returns to its normal mode without saving the new changes.)
•
To accept the requested parameter changes, press the SEL button. A
CONF
YES
message displays, and
the display returns to its normal mode after saving the new changes.
No dip switches or jumpers are required to provision the HLU-231 as it contains a non-volatile
RAM (NVRAM) which stores the system option settings. System option settings are retained if
shelf power is lost or if the HLU-231 is unplugged.
