Painless 57002, Инструкция по эксплуатации

Страница: 6 / 62

2
TOOLS NEEDED
This installation primarily requires only basic hand tools that may
include, but are not limited to:
1. Wrench sets SAE and Metric
2. Ratchet sets SAE and Metric
a.
¼” Drive w/ an extension is recommended
for some tight areas of the install.
b. T30 Torx driver
3. Screwdrivers:
a. (2) #2 Standard Length and Stubby Phillips
Head
b. #2 Flat (slot) Head
c.
#0 “Jewelers” Flat (slot) Head
4. Inch/Pound Torque Wrench
5.
Diagonal Pliers or “dikes”
6. Wire Cutter/ 18-10 ga. Stripper
7. Hand Crimpers
8. Cable Cutters
9. Cable Crimping Tool
10. Hammer
In addition to these basic hand tools,
you may need the following:
Volt/Ohm Meter:
A Volt/Ohm meter is always a good tool to
have on hand when installing any type of
electrical component into a vehicle. The most
basic meters provide the two functions required
to diagnose electrical issues commonly seen
during a harness install. These two functions are
the ability to read DC Voltage and electrical
continuity or Ohms. They can be purchased
from any home improvement store, local
hardware store and electrical supply shop and
online.
Heat Gun:
Very useful to shrink the heat-shrink found in the
parts kit.