Painless 57002, Инструкция по эксплуатации

Страница: 41 / 62

37
Step 44: Now, strip the factory pink /white, 22-gauge wire 3 ∕
8
” . Once
stripped, fold the copper wire in half to ensure a tight connection
to the butt connector. Then, slide a piece of
heat shrink over the
factory wire and crimp it into the open end of the butt connector
on the
ignition pigtail . (NOTE: make sure the heat shrink is
installed before crimping).
Step 45: After crimping, slide the heat shrink over the connection.
Using a heat source, heat the heat shrink ensuring a tight wrap
around the connector.