3
INSTALLATION
First, decide what switches will be used for your
application and install them into the panel. Start by
adjusting the hex shaped backing nut on each of the
switches ¾ of the way back toward the body of the switch.
Insert the switch through the switch hole opening
with the slot on the threads facing down and screw the black
toggle switch boot onto the front of switch by hand until
snug.
Next, using either a
5
∕
8
”
or a
16mm
deep wall
socket hold the switch boot in place while tightening
the hex shaped backing nut to fully secure the switch
to the panel. Tightening the switch using the nut
inside the switch boot could damage the shoulders
around the boot.
In order to allow the maximum amount
of room for the switch labels, line the switch
boots up with the flat sides of the hex-shaped
nut running parallel with the top and bottom
sides of the switch panel.
Install the keyed ignition switch into the
switch panel. Pass the key through the
weather-resistant retaining nut and then insert the key into the ignition switch cylinder.
Tighten the weather-resistant retaining nut by hand using the key to properly align the
switch. The key should face up and down in the off position. Next tighten the ignition
switch backing nut to fully secure the ignition switch to the panel.
NOTE: A thread
locker may be used to assist in keeping the ignition switch nut from vibrating loose.