11
ENGLISH
Auto-Chl 12 & 25
ENGLISH
MA60-17E
Preparations
Add at least 4 kg of salt per m³ of pool water. The salt must have a purity rating of at least 98% and shall be poured directly into
the pool or into the equalizer tank.
Ensure that all the salt has dissolved before starting the chlorinator. It may take a day for the salt to dissolve. Salt dissolves
faster in warm water. If the salt content is not sufficiently high, the system will issue an alert and switch off.
Display
Default gives a steady readout of the chlorinator’s chlorine production capacity in %.
The yellow lamp lights up when power is supplied to the electrolyte.
The display returns automatically to the default setting one minute after the most recent
button activation.
Chlorine production
Press the arrow key
▲
or
▼
to increase or decrease chlorine production.
The production range is 4-100 %.
E.g.: When production is set at 50% the current to the electrodes is on for 30 seconds
and off for 30 seconds.
Indication of current salt content
Scroll ahead in the menu by pressing
▲
and
▼
at the same time.
SAL
and current salt
content will flash alternately.
The value shown is kg/m³ pool water (ppt = parts per thousand).
The display automatically returns to showing chlorine production (the default display) after one minute.
Calibration
First measure the salt content of the pool.
Scroll ahead in the menu by pressing
▲
and
▼
at the same time. When
SAL
,
CAL
and a statistical value flash alternately,
calibrate the value by scrolling to the correct figure using
▲
and
▼
. The calibrated value will then be displayed as a steady read-
out. The display automatically returns to showing chlorine production (the default display) after one minute.
Temp.sensor
Flow switch
Redox Off
Redox On
Memmory
card
1. Signal
2. ±0V
3. +3,3V DC
4. Signal
5 Signal (oc+)
6. ±0V (oc-)
Top side
Control and power card
Display
Cell
Bottom side
Control and power card
Redox
