U5007A PAGLOK POWER MODULE INSTRUCTION MANUAL
U5007A PAGLOK POWER MODULE INSTRUCTION MANUAL
4.1
The Power Module is not intended for any use other than the
sequencing of battery power output as detailed in Section 2
‘Specification’.
4.2
Use only with batteries of the correct rating. See Section 2
‘Specification’ .
4.3
Ensure that the ventilation slots are not obstructed when in use,
e.g. do not site on a deep pile carpet, or cover when in use.
4.4
The Power Module is extremely rugged and designed for arduous
service conditions, but it should not be used if it has received
a severe drop or blow, or been otherwise damaged in any way.
It should be returned to your local dealer, or direct to PAG Ltd.,
London, for service or repair.
4.5
Unqualified personnel should not attempt disassemble the Power
Module (see paragraph 4.1 above). Any such interference would
invalidate the guarantee and invariably cause more damage than the
original fault. There are no user-serviceable parts inside, and
incorrect reassembly may result in a safety hazard.
4.6
In the unlikely event of a fault developing, seek advice from
your nearest PAG dealer or direct from PAG Ltd., London, by
telep44 (0)20 8543 3131.
3.9
The sequence will continue until all the connected batteries
have been used.
3.10
Batteries may be disconnected and others connected as
necessary to enable continuous running to be achieved.
3.11
A carrying strap is provided with each Power Module. Each end
of the strap is fitted by locating it over the mushroom lug and
pulling upwards to lock it in place. Removal of the strap is achieved
by reversing the above procedure.
CARE & MAINTENANCE
SECT ION 4
5.1
Not withstanding any provision of any agreement the following
warranty is exclusive: PAG Limited warrants each PAGlok Power
Module it manufactures to be free of defects in material and
workmanship under use and service for two years from the date of
purchase. This warranty extends only to the original purchaser. This
warranty shall not apply to fuses or any product or parts which have
been subject to misuse, neglect, accident or abnormal conditions of
operation.
5.2
In the event of failure of a product covered by this warranty, PAG
Limited will repair and calibrate equipment returned to an
authorised Service Facility within the period of the warranty,
provided the warrantor’s examination discloses to its satisfaction
the product was defective. The warrantor may, at its option, replace
the product in lieu of repair. With regard to any equipment returned
within this period, said repairs or replacements will be made
without charge. If the failure has been caused by misuse, neglect,
accident or abnormal conditions of operation, repairs will be billed
at a nominal cost. In such a case, an estimate will be submitted
before work is started, if requested.
5.3
The foregoing Warranty is in lieu of all other warranties, express
or implied, including but not limited to any implied warranty of
merchantability, fitness or adequacy for any particular purpose or
use. PAG Limited shall not be liable for any special, incidental, or
consequential damages, whether in contract, tort, or otherwise.
WARRANTY
SECTION 5
5
6
