U4898A VEHICLE BATTERY POWER CONVERTER INSTRUCTIONS FOR USE
U4898A VEHICLE BATTERY POWER CONVERTER INSTRUCTIONS FOR USE
Operational Information
When positioning the unit ensure that there is no tension on the input
lead.
Do not cover the unit as it retains heat if used at high power for an
extended period.
Never leave the unit connected when not in use. If you do it will continue
to draw current, slowly discharging the battery.
Never use with any appliance rated above 120W.
Safety
WARNING:
This unit produces a very high DC voltage level. To ensure
continued safety you
MUST
adhere to the following instructions:
Never extend or tamper with the input or output leads.
DO NOT OPEN THE UNIT TO INVESTIGATE MALFUNCTION.
Sufficient energy may remain stored in the unit to cause
SERIOUS INJURY
up to 30 minutes after it has been disconnected from the vehicle battery.
Lack of output is not an indication of safety.
Connecting a load does not discharge the internal circuits.
TAMPERING WITH THE UNIT WILL INVALIDATE THE WARRANTY.
Always use with equipment satisfying international safety standards.
Treat the output with the same caution as a 13A mains socket.
Consult your PAG Dealer or a qualified electrical engineer if in doubt about
any proposed permanent installation.
CAUTION: THIS UNIT IS FOR IN-VEHICLE USE ONLY.
PROTECT FROM
MOISTURE.
Every
time you use the unit or any electrical appliance, check that all
connections and screws etc. are tight, and that there is no damage to wire
insulation. Make sure that cables do not chafe on sharp objects.
3
