6. Maintenance Instructions
Dust Bag Replacement
1. Turn off the vacuum cleaner and unplug it from the
power point. Remove the hose and unclip the retainer
clips on either side of the machine and remove the lid,
by lifting from the handle. (Fig.6_1)
2. Lift out the filter cage assemble, to access the dirt
container compartment. (Fig.6_2)
IMPoRtant: always unplug the
vacuum cleaner from the electrical
outlet before removing the dust bag.
IMPoRtant: Do not use the
vacuum cleaner without aLL of the
filters in place.
3. Remove the full dust bag and dispose. Insert a new dust
bag by aligning the downward arrow on the front of the
dust bag to the bottom of the container over the air
entrance.
note: the seal ring around the dust bag
opening should cover the air entrance connector
inside the housing.
(Fig.6_3)
Pre-motor filter
1. Turn off the vacuum cleaner and unplug it from the
power point.
2. Unclip the retainer clips on either side of the vacuum
cleaner and remove the lid. (Fig.6_4)
3. Rotate the filter-retaining disc clockwise to gain
access to the filter, or HEPA filter, which can then
be lifted out to remove (Fig.6_5)
www.pacvac.com
Support: 08 9479 1444
6. Maintenance Instructions (cont’d)
note: Pacvac recommends cleaning or replacing
the pre-motor filter or HePa filter should it become
discoloured or dirty.
4. The pre-motor filter must then be returned to the
vacuum cleaner before use and the retaining disc
turned clockwise to secure (Fig.6_6)
filter cage assembly
1. Turn off the vacuum cleaner and unplug it from the
power point.
2. Unclip the retainer clips on either side of the vacuum
cleaner and remove lid. Lift out the filter cage. The
filter on the cage may be brushed to clean if dusty
and replaced with a new filter when required. (Fig.6_7)
fig.6_1
fig.6_2
fig.6_3
fig.6_4
fig.6_5
fig.6_6
fig.6_7
3. The filter can then be removed from the cage by hand.
It can be re-attached by putting on a new filter. The
filter must then be attached to the cage before the
vacuum cleaner is used. (Fig.6_8)
fig.6_8
6
7
