3. assemble Instructions
1. Insert the flexible hose into the inlet on the main
body of the vacuum cleaner. Turn the hose
clockwise until it cannot be turned any further (Fig.3_1).
2. Push the wand on to the end of the handle.
The wands can be used together to lengthen or
shortened by using one section of the wand as
required.(Fig.3_2).
3. Fit the combination floor tool by pushing onto the
wand. (Fig.3_3).
www.pacvac.com
Support: 08 9479 1444
Cable Storage
After use, turn the vacuum cleaner off and unplug from
the power point. Wrap the cord around the cable
storage hook for moving the unit from room to room or for
storage. (Fig4_4)
Hose Storage
For convenience there is a parking slot located at the
rear of the vacuum cleaner, where the wand may be
parked for carrying and storage. (Fig.4_5)
5. accessories
The accessories can be attached directly to the handle by
removing the wand and pushing in the desired accessory.
The accessories can also be attached to the wand for extra
reach. Remove the combination floor tool and push on the
desired accessory.
Crevice tool
For crevices, corners, cracks etc.
Dusting Brush
For delicate surfaces.
upholstery tool
For sofas, chairs etc.
fig.3_1
fig.3_2
fig.3_3
4. operation Instructions
on/off Button
Insert the power plug into the power point. Ensure the
vacuum cleaner is switched off. Press the on/off button
located on the top of the machine to turn on and press the
button again to turn the vacuum cleaner off. (Fig.4_1)
floor tool
The Floor Tool supplied can be used on carpets and
hard floors. (Fig.4_2)
Carry Handle
Use the carry handle located on the top of the machine
to move the vacuum cleaner from room to room.
(Fig.4_3)
fig.4_1
fig.4_2
fig.4_3
fig.4_4
fig.4_5
4
5
4. operation Instructions (Cont’d)
