BG02 Multi-circuit Power Monitor
Quick Start Guide
IMPORTANT
1.
Installation should be conducted by a qualified professional according to local electrical codes.
2.
Protective equipment should be used when handling a current transducer (CT) on a live conductor.
3.
Do not make adjustments to the BG02's internal wiring.
4
If you believe the BG02, CTs, or leads have been damaged, do not attempt to repair or use them.
COMPONENTS
Chase nipple
BG02 Multi-circuit monitor
with lock nut
Ground wire
Voltage lead(s)
CT leads with quick connectors
Current Transducers (CTs)
with quick connector
TOOLS NEEDED
12" adjustable wrench
-- to tighten chase nipple
12" adjustable claw pump pliers
-- to tighten lock nut around chase nipple
#2 Phillips screwdriver (minimum 4" shaft)
-- to remove device cover if needed
#5 drill bit
-- to make mounting holes in wall
#5 screws
-- to attach mounting tabs to wall
INSTALLATION STEPS
See next page for more detail by step.
The BG02 does not need to be configured prior to use.
Mount BG02 to wall or device using attached mounting tabs
Run CT leads from the BG02 to device being monitored
Connect CTs to the conductors
Connect CT tails to the CT leads coming from the BG02
Run the voltage leads to the voltage source and connect by line and ground
Once power is supplied, the BG02 will automatically begin to transmit data.
©
2019 Packet Power LLC
www. packetpower.com/support
BG02 QS V1
This is a summary of how to install a Packet Power BG02 multi-circuit monitoring device.
1
2
3
4
5
