Page
|
3
GATEWAY TO SMARTER TELECOMS
ADDING YOUR UNIT TO
SERVER LIST
Click the “add” link contained in the
title.
Please note that adding units
using the Firefox browser will not
work. Please use IE6 or later.
Next will be presented a box of fields where the
various gateways details can be defined.
Address:
This is
the local LAN
address of the unit
– the default is
192.168.0.2
Port:
This is the admin port for the unit. Leave as 8878
ID:
Usually a numerical value such as 001 but not required.
Pass:
The default password for the unit is “hypergateway”
Comments:
You may define the unit’s purpose, for example enter “SMS gateway”
Save as:
Will be the “server name” seen in the example blow. A logical name such as
your company name is sufficient. Now click save to add unit to the server list.
The server list entry should be like the above example now allowing the new IP address
of the GSM gateway to be set.
SETTING THE IP ADDRESS OF THE UNIT
For this section you will require the laptop/desktop
with the management software pre-installed to be
connected directly to the LAN 1 port on the PC card in
the gateway (pictured left). The port is auto sensing
so a x-over cable is not required.
Connect your laptop/desktop’s LAN port to the
gateways “LAN 1” port with a standard straight
through Ethernet cable. The gateways default IP
address is 192.168.0.2 so set the computer with an
IP address in the same class/subnet. Use
192.168.0.5 with a subnet mask of 255.255.255.0 for
example.
