Packard Bell oneTwo L5860, Руководство по обслуживанию

Страница: 87 / 137

Packard Bell oneTwo L5860 / L5861 AIO Computer Service Guide 79
Configuring the ME Firmware
You need to disable the Manageability Engine (ME) firmware before updating the BIOS. Use the
ME_DISABLE jumper to do this.
• 1-2 position: Normal operation (default)
• 2-3 position: ME disable
To disable the ME firmware:
1. Turn off the power to the computer and all peripherals.
2. Unplug the power cord from the computer.
3. Unplug the network cable and all connected peripheral devices from the computer.
4. Place the computer on a flat, steady surface with the rear cover facing upward.
5. Remove the computer stand, rubber feet, rear cover, and the I/O cable plate by following the procedures
described on pages 26–28.
6. Remove the wall mount plate by following the procedure described on page 36.
7. Remove the graphics card and HDD assemblies by following the procedures described on pages 39–42.
8. If necessary, remove any other assemblies or cables that prevent access to the ME_DISABLE jumper.
9. Locate the ME_DISABLE jumper on the mainboard.
10. Remove the jumper block and set it over the 2-3 pins for 20 to 30 seconds.
11. Return the jumper block to its default 1-2 position.
12. Reinstall the graphics card and HDD assemblies.
13. Reinstall any any other assemblies or cables that have previously been removed.
14. Reinstall the wall mount plate, I/O cable plate, rear cover, rubber feet, and the computer stand.
15. Connect the power cord to the system.
16. Press the power button to turn on the computer.
17. During POST, press Delete to access the Setup Utility.
18. Press F9 to load the system default values.
19. Press F10 to save the changes you made and close the Setup Utility.