MACHINE PREPARATION
4. SQUEEGEE ASSEMBLY INSTALLATION
The squeegee is assembled to the machine by lifting the locking latches and sliding the
squeegee assembly onto the 2 posts at the rear of the squeegee swing arm. Push on the
locking latches down. Lower the squeegee and install vacuum hose over vacuum outlet
on squeegee assembly. The hose should be located to the rear of the lifting cable
5. ADJUSTING SQUEEGEE HEIGHT
The height from floor to squeegee should be adjusted based on blade wear. Rotate the
adjusting knobs counter-clockwise to lower squeegee and clockwise to lift it
NOTE:
Rotate the right and left adjusting knobs until the squeegee is positioned parallel
to the floor
6. ADJUSTING SQUEEGEE INCLINATION
During operation the rear squeegee blade is most efficient when bent backwards roughly
3/16
ths
to 5/16
ths
of an inch along its entire length.
To increase the blade bending in the
center of the squeegee, tilt the squeegee body backward by turning the adjuster knob
counter-clockwise. Conversely, turn the adjuster knob clockwise to increase the bending
at the outside edges of squeegee blade
5
