Pacific WAV-26, Инструкция по эксплуатации и каталог запасных частей

Страница: 4 / 20

4
WARNING! For the safe operation of this machine follow the instructions given in this booklet and the training given by
your supervisor. Failure to do so can result in personal injury and/or damage to machine and property!
DO NOT OPERATE MACHINE IN AN EXPLOSIVE ENVIRONMENT!
NEVER USE THIS MACHINE TO PICK UP VOLATILE OR EXPLOSIVE MATERIALS!
The model shown in this manual is intended for commercial use.
PREPARATION
To prepare the machine for operation, make sure it is of correct voltage and properly assembled. If in doubt, ask your supervisor.
1.
Properly install the filter bag in the vacuum:
Use the latch at the rear of the machine (opeator’s position). Tilt the cover
back until it is fully open. The filter bag inlet is designed with a rubber gasket that fits securely over the bag adapter. Push
the filter bag inlet over the adapter until it contacts the inside of the cover. Replace the filter bag when full.
OPERATION
1. Plug the machine’s power cable into a properly grounded outlet (see Grounding Instructions).
2. Depress the foot pedal to tilt the handle back to the operating position.
3. Adjust the brush height with the lever located on the right side of the machine near the floor.
4. Turn the switch ON and begin vacuuming .
OPERATION WITH TOOLS
An optional on-board tool kit is available for the vacuum - Part Number 655003. This kit includes an onboard tool bag, a dust-
ing tool, crevice tool, stretch hose assembly and two piece wand assembly. Fifteen (15) feet of hose is provided which allows
access to rooms without moving the machine.
1. The switch should be turned OFF.
2. Depress the foot pedal to tilt the handle into the upright position. The brush will be off the floor in this position.
3. Remove the bottom hose cuff from the base of the machine and attach the accessory hose by pressing the insert located
within the cuff of the accessory hose together with the cuff of the machine hose until there is a tight fit between the
two hoses. Then attach the tool of choice.
4. Turn the switch ON and begin.
Note: The switch should be OFF when switching between the accessory and the brush positions.
MAINTENANCE
ALWAYS turn the switch OFF and UNPLUG the power cord from the electrical outlet before doing any clean-up or repairs,
and when the machine is left unattended.
AFTER EACH USE:
1. Vacuum filter bag: If the bag is full or damaged install a new one.
Filter Bag, 10 Pack – Part Number 650605
Cloth Bag (optional) – Part Number 650606
2. Power cord and plug: Check for cuts or nicks; if damaged, have the cord replaced at a factory authorized service center.
3. Wheels: Remove any strings or debris that may restrict the free movement of the wheels.
4. Tools: Inspect the tools to ensure there is no obstruction of airflow. Remove any debris found.
5. Brush: Remove any strings or debris. Replace if it becomes worn or damaged.
OPERATING INSTRUCTIONS