10
MACHINE PREPARATION
12.
SOLUTION TANK
Unscrew the water inlet plug and confirm the solution filter, located on the bottom
left side, is properly assembled.
13.
SOLUTION WATER
Fill the solution tank with clean water at a temperature not more than 50
°
C/122
°
F.
Add the proper concentration of liquid detergent by following the manufacturer in-
structions. Excess foam in the recovery tank can damage the vacuum motor, so use
only the minimum amount of detergent necessary. Reassemble the cover.
14. ADJUSTING THE BRUSHES
Both brushes should have the same amount of contact with the floor, along their
whole length.
1.
Lower the brushes, set the emergency brake and turn the brushes on.
2.
Turn the knob (1) to adjust the brush pressure.
3.
Turn the screw (2) to obtain equal contact of the brushes with the floor (tightening
the screw will increase pressure on the rear brush).
WARNING!: Always use low foaming detergent. Adding antifoam
liquid into the recovery tank before cleaning will also help prevent
foaming. NEVER USE PURE ACID.
Содержание Floormaster 18B
Страница 19: ...19 NOTES...
