Heritage Series ADSL Bridge/ Router
Quick Guide
9
8. Beside Use DHCP, place the black dot beside Enable.
9. Beside Default Route, use the drop down menu and select Enabled
10. DO NOT MAKE ANY OTHER CHANGES.
11. Click on the Submit button.
12. Click the Admin tab, and then click Commit&Reboot in the task bar.
13. Click
to save changes to permanent storage.
14.
Turn off SSABR-B/SSABR-BU, wait 5 seconds and then turn it
back on.
1.2.3 RFC 1577 Routed Mode (IPoA)
1. Beside ATM Interface, you can setup up to 8(0~7) interface. The default
interface number is 0.
2. Beside Operation Mode, please choose Yes to enable this interface.
3. Beside Encapsulation, use the drop down menu and select 1483 Routed
IP LLC(1577).
4. Beside VPI, enter in a value (please consult your ISP for your VPI.
Factory default is 0).
5. Beside VCI, enter in a value (please consult your ISP for your VCI.
Factory default is 35).
6.
Beside Bridge, use the drop down menu and select Disabled.
7.
Beside IGMP, use the drop down menu and select Disabled to accept
multicast.
8.
Beside IP Address, enter your static IP address get from DSL service
provider.
9.
Beside Subnet Mask, enter your subnet information get from DSL
service provider.
10. Beside Use DHCP, place the black dot beside Enable.
11. Beside Default Route, use the drop down menu and select Enabled
12. Beside Gateway IP, enter your Gateway IP Address get from DSL
service provider.
13. DO NOT MAKE ANY OTHER CHANGES.
14. Click on the Submit button.
15.
Click the Admin tab, and then click Commit&Reboot in the task bar.
16.
Click
to save changes to permanent storage.
17.
Turn off SSABR-B/SSABR-BU, wait 5 seconds and then turn it
back on.