Setting of basic parameters DIN-3G communicator
Description of configuration software for DIN-3G
• The device name is used for naming-communicator. This name will be displayed at the beginning of each SMS that send DIN-3G.
• Phone numbers - DIN-3G can communicate with up to six phone numbers with international code that you enter in this list
• Setting Phone Numbers – allocation for individual numbers setting
• Set input 1 and 2 - setting behaviour of inputs
• Set the relay 1 and 2 - setting behaviour of outputs
• System Time - synchronisation time with PC
• Password - used to change the password for the program, and SMS commands (default password is 1234). To save the password, it is
necessary to save the configuration, click Save to the device. Attention: The password must be four digits long and consist only digits.
• Bottom Status Bar - displays the network operator, the current status of the network signal and battery firmware version DIN-3G store
and process configuration.
Advanced settings DIN-G3 configuration software
• Starting value - setting the activation / deactivation, inputs and status outputs when communicator reset
• Entry and exit time- setting of timers
• Thermostat setting – setting of high and low limits include relay reaction
• ON/OFF commands- setting the SMS commands for arming and disarming inputs
• Service setting – setting of automatic status SMS and Information SMS temperature limits
• Power cut- if enabled, the service authorization numbers receive SMS in the event of a main power 230V failure
• Low battery - if enabled, the service authorization numbers receive SMS in case of low battery (25% or less)
• Temperature Sensor - if enabled, the service authorization numbers receive SMS in case of disconnection or failure the sensor
Table 1 – Phone Numbers:
Inputs 1 and 2
Set input 1 or input 2 to the alarm receiving phone number
Outputs 1 and 2
Set the number to control relay 1 or relay 2 via call. Beware, this function is not compatible with the function of
activation and deactivation calling option – see function below the A / D
Call
The alarm will be reported via call
SMS
The alarm will be reported via SMS
A/D
Control the activation and deactivation inputs vial call. Beware, this function is not compatible with the output
control call function.
Service
This number will be receiving service SMS reports*
* Service SMS by default: information on lost / restore 230V can also enable automatic sending of SMS status if exceeding temperature
set limits
Table 2 - Setting of input1 and input2:
Text SMS
Entre the text which will receive if alarm
Input reaction
Connecting- SMS alarm if input connected to GND, disconnecting – SMS alarm if input disconnected from GND,
Status Change – SMS alarm responding to connection and disconnection GND, ARM / DISARM – if input
connected to GND, the communicator is disarm when not connected to GND, is arm.
Input mode
ARM / DISARM - SMS alarm is triggered only if communicator arm. 24 hours - input always send SMS (e.g. for
the use of fire sensors, gas etc.).
Delay
Indicates how long must be GND connected or disconnected in input before SMS send out
Relay1 ON
When input activating SMS alarm input also switch output 1. The output reaction is subject to settings of output1
Block 15
The triggered input will be blocked to send SMS for next 15 minutes
