Pacific Floorcare SCE-20, Инструкция по эксплуатации и частям

Страница: 21 / 43

MAINTENANCE
SCE-20 C 9.808-371.0
4-2
Only qualified maintenance personnel are to
perform the following repairs.
Seul le personnel d'entretien qualifié peut
effectuer des réparations.
1. Turn off all switches and unplug machine.
2. Remove recovery tank.
3. Remove the (2) screws that fasten the solution
tank to the frame, and tilt tank back to expose
the inside of the frame.
4. Locate the vacuum motor wires and disconnect
at the connector. Close the solution tank.
5. Remove the (6) screws holding the vacuum
motor cover 86003080 (PRV NO. 27809) to the
solution tank.
6. Remove the vacuum motor.
7. Reverse process to install vacuum motor.
3
8
[9.5 mm]
Carbon
Brushes
End Cap
If armature commutator is grooved, extremely pitted or not
concentric, the motor will need to be replaced or sent to a
qualified service center.
Important:
These brushes wear quicker as the length shortens due to
increased heat. Spring inside brush housing will damage
motor if brushes are allowed to wear away completely.
Periodically check the length of the carbon brushes. Replace
both carbon brushes when either is less than 3/8" (9.5mm)
long.
WARNING:
The green ground wire must be attached for
safe operation. See wiring diagram.
AVERTISSEMENT: Le fil à la terre vert doit être attaché
pour un fonctionnement en toute sécurité. voir le schéma
de câblage.