Pacific energy E Series, Инструкция по установке и эксплуатации

Страница: 7 / 20

7
Fig. # 8
Burner Installation
If the glass frame assembly is installed, it must be removed to
install the burner into the firebox. The glass frame is held in
place by two over-center latches located under the firebox.
1) Fold down the bottom louver, if installed, to access the
over-center latches. Disengage the latches by pulling
each lever down and forward.
2) Grasp the sides of the frame and swing the bottom out to
clear. Lift up and forward to disengage from the top.
Place the glass frame assembly in a safe place to avoid
damage.
3) Remove the logs and set aside, taking care not to damage
them.
4) Remove the bottom left and right "brick-like" panel from
the burner box and install under the side panels inside the
firebox.
5) Remove burner assembly from the carton and inspect for
damage. Do not use if damaged.
7) Position the burner assembly inside the firebox so that the
side mounting holes are aligned. Fasten the burner in
place with the screws provided (Fig. #9 and #10).
8) Place the self-adhesive label into the blank box provided
on the rating label to designate the type of gas the appli-
ance is connected to.
A knockout is provided at the bottom right rear of the
appliance as an alternate inlet for a gas supply line. To use this
inlet, remove the knockout from the rear of the appliance.
Remove the plastic bushing installed in the side and reinstall
into the hole at the rear of the appliance.
Fig. # 10
Left and Right Bottom Panels
Pilot
Burner
Attachment
Point
Optional
Blower
Cord Exit
Rear Knockout
Gas Inlet
Fig. # 9
Burner Front Attachment Point
f i r e - p a r t s . c o m