Pacific energy Classic Gas, Инструкции по эксплуатации и монтажу

Страница: 22 / 32

The optional blower kit (kit #WODC.BLOW) is equipped with a three prong power cord and may be installed at
any time. Follow installation instructions supplied with the kit. Route power supply cord away from heater.
Electrical rating: 115 volts A.C.-1.02 amps.
Fan output rating: 140 CFM
Blower Operation
Proper blower speed matched with air control setting will ensure peak performance from your stove. Operate
as follows:
• Air control set to "L" (low), operate blower speed control on "Low".
• Air control set between "L" and "H" (low and high), operate blower speed control at desired setting.
Automatic:
To operate the blower automatically, set the rocker switch on the side of the fan housing to
"Auto" and set the speed control to desired setting. This will allow the fan to turn on as the stove heats up to
operating temperature. It will also shut the blower off after the fire has gone out and the unit cooled to below a
useful heat output range.
Manual:
To manually operate the blower, set the rocker switch to "Man" and set the speed control to desired
setting. This will bypass the sensing device and allow full control of the blower. Switching from "Auto" to
"Man" or selecting speed may be done anytime.
Optional Outside Air Adaptor
The adaptor is only required if the blower kit is to be installed and outside combustion air to be ducted to rear
of pedestal.
Installation:
Remove blower kit if already installed. Place adaptor with the 4"(100mm) round hole facing up and opposite
end covering the room air knockout hole on the back of the pedestal. Mark attachment holes on pedestal
base and drill with 1/8" bit. Attach with #8 x 1/2" screws and reinstall fan. Combustion air duct from outside
can now be attached to the 4"(100mm) round collar.
Optional Blower
SUPER-SD1_100517-32
22 5055.201
SUPER-SD1_100517-32