14
Getting On and Off The Power Wheelchair
The following is a recommended method for getting on your Power Wheelchair
1. The wheelchair should be stopped on a fl at, level surface with the power switch in the OFF posi-
tion (no visible lights).
(SEE WARNING BELOW)
2. Raise the foot rest plate so that you may back up to the wheelchair squarely.
WARNING:
Do not use the
footplate as a platform. When getting in or out of the wheelchair make sure that the footplates are in the up-
ward position or swing footrest towards the outside of the wheelchair.
We realize that many bariatric persons can not do a side transfer or raise their legs to raise and lower the foot-
plate. If and only if you must step on the footplate for entering or exiting the power wheelchair, you must fol-
low these instructions. Your power wheelchair is equipped with a patented infi nitely adjustable rigid anti-tip
system (see fi gure 1 under Battery Removal Section). When both of the front anti-tip wheels are lowered to
contact the fl oor, you can step on the platform without tipping the chair forward. After entry the wheels must
be raised to adjust to the driving environment - 1/4” for fl at fl oors and up to 2” for outdoor terrain. Always
keep the adjustment as low as possible for your driving area.
Warning:
Failure to lower the anti-tip wheels
for entry and exit will result in the chair tipping forward when you stand on the footplate which can cause you
to fall and result in possible serious injury.
Warning:
As with any wheelchair part should the anti-tip assem-
bly become damaged, discontinue use immediately and contact your dealer for service.
Warning:
Always
keep anti-tip wheels at the same height from fl oor to prevent tipping to side.
3. Position yourself squarely in front of the seat and lower yourself into the seat using the armrests if neces-
sary. (Never use the control housing or joystick as a support while getting on and off the wheelchair.)
4. Lower the footrest and place your feet securely on the footrest.
5. Buckle the safety belt around yourself belt to help hold yourself securely in the chair.
6. Push the power button on the speed control, the LED lights should activate.
7. When seated comfortably, you can drive the power wheelchair.
The method for getting off is the reverse procedure.
1. Turn the power switch OFF when stopped (no visible lights).
2. Unfasten your safety belt and raise (or have someone raise) the footrest bracket.
3. Make sure your feet are planted fi rmly on the ground and stand up.
WARNING
Keep the power button in the OFF position at all times when stopped or when getting on or off the wheel-
chair. Sudden accidental movement of the wheelchair will be avoided with the power switch in the OFF
position.
Tipping can occur if you get on the power wheelchair in a manner other than recommended. Tipping can be
avoided by keeping your weight away from the outer edges until seated. If you step into the wheelchair, sit
directly in the center of the seat, not near the edge. Tipping, loss of control or traction (wheel spin) can also occur
if you turn the joystick sharply while traveling at or near full throttle and on slick surfaces or inclines.
Содержание Scout
Страница 37: ...37...
