Pace 8007-0387, Руководство по эксплуатации и обслуживанию, Страница: 7 / 21

System Operations Manual, Rev B
www.paceworldwide.com Page 7 of 21
System Set-Up
Set up the HW 100 or TW 100 systems using the following steps and associated images.
1. Store the shipping container in a convenient location. Reuse of these
containers will prevent damage if you store or ship your system(s).
2. Place the Power Switch in the “OFF” or “0” position. See Figure 2.
Mounting Options
The HW 100 and TW 100 can be placed directly on a work surface or can be
mounted under a workbench or shelf to conserve space using the optional power-
source mounting bracket. To mount the system in this way:
1. Mount the bracket in the desired location (fasteners not supplied).
2. Remove the top two screws from the power source case.
3. Fit power-source to mounting bracket
4. Replace power source screws and tighten by hand.
Tip & Tool Stand
The Tip & Tool Stand is usually placed on the workbench next to the power
source. It can also be mounted to the power source using the optional Power Source/Tool Stand
Interlock (P/N 1335-0251-P1). See Figure 4. When the Interlock bracket is used, the Tool Stand may
be attached to a power-source that has been mounted under a workbench or shelf. See Figure 5. It
is important to note that the Interlock can be mounted on
either side of the power-source. In the examples below,
the Tool Stand has been mounted on the left of the
power-source. To mount the Tool Stand on the right
side of the power-source, simply flip the Interlock over.
1. To attach the Tool Stand to the power-source:
a) Remove the two outside feet from the
power source.
b) Remove the two outside feet from the Tool Stand.
c) Place the Interlock bracket over the base of the power
source so the remaining feet pass through large holes
d) Reinstall the removed power-source feet through the small
holes in the Inlerlock.
e) Place Tool Stand on Interlock bracket and align remaining
feet with large holes in Interlock bracket
f) Reinstall removed Tool Stand feet through the small holes in
Interlock bracket.
2. Place the handpiece into its Tip & Tool Stand.
Adjusting the Angle of the Cubby
The angle of the Handpiece Cubby may be adjusted by loosening the angle
adjustment screw slightly, adjusting the cubby to the desired angle, and
tightening the adjustment screw. See Figure 6.
Handpiece Connection
Connect the handpiece connector plug into the Power Receptacle in the following manner.
1. Align guide on the connector with slot on power receptacle.
Figure 6
Figure 5
Figure 4
Figure 3
Figure 2
On/Off
Switch