Pace Technologies PICO-200, Инструкция по эксплуатации

Страница: 16 / 20

PICO-200 Table Saw
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
I
NSTRUCTION
M
ANUAL
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1-520-882-6598 Fax +1-520-882-6599 email: pace@metallographic.com Web: https://www.metallographic.com
11
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
4.5 Cutting (Step-by-Step Procedure)
1. Ensure sample is secured properly to the table’s surface (see reference
section Securing a Sample above).
2. Close the PICO-200 acrylic hood.
3. Power on the PICO-200.
4. Set the desired rpm using the speed adjustment knob.
5. Press the green start button.
6. Rotate the blade travel knob to move the blade into the sample.
7. Adjust feed rate as needed.
8. Once the sample is cut all the way through, press the red stop button.
9. Open the hood and undo the vices, then take the sample out.