Pace Technologies PICO-200, Инструкция по эксплуатации, Страница: 15 / 20

PICO-200 Table Saw
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
I
NSTRUCTION
M
ANUAL
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1-520-882-6598 Fax +1-520-882-6599 email: pace@metallographic.com Web: https://www.metallographic.com
10
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
4.4 Securing a Sample
Note:
If a sample is unable to be properly secured on the tables surface, a larger
abrasive saw such as a MEGA M250 can be used to create a flat surface.
1. Using the blade travel knob, move the blade towards the back of the
machine.
2. Position the vertical vice(s) in the desired configuration by sliding the square
nut through the slots on the T-Slot table.
3. Orient the sample in front of the blade.
4. Rotate the vices so that the arm is over the top of the samples surface.
5. Tighten the vice down onto the table buy rotating the large screw on the
back side of the vice.
6. Rotate the T-bar on the top of the vice until it touches the samples surface.
Apply some pressure onto the sample. If using more than one vice, repeat
steps.