Pace Technologies MEGA-T400A, Инструкция по эксплуатации

Страница: 18 / 36

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
I
NSTRUCTION
M
ANUAL
MEGA - T400A
Abrasive Cutter
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 - 520 - 882 - 6598 Fax +1 - 520 - 882 - 6599 email: pace@metallographic.com Web: https://www.metallographic.com
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
4.2.1 Control Panel Screen
START UP SCREEN
After turning on the main power switch
the START UP SCREEN will be
displayed.
The MEGA - T400 operating screen is a
touch screen
To select the following parameters touch the screen parameter.
Adjust the parameter in the secondary screen that is displayed
Select FEED MODE
as constant or by
Pulsing based on
parameters set in
SETTINGS
4.2.2 Control Panel Screen - Parameter Adjustments
13
Select Cutting
mode to either
AUTO or MANUAL
Parameters will be
highlighted in
orange when
Amperage
the motor is
pulling (see
details for
Actual Operating
OPERATING SCREEN
Set Operating
Speed
Sets the
number of
Set Y - axis feed
rate
Set Depth of cut
in y - direction
Sets the width of a
serial cut (adds
the width of the
blade as chosen in
SETTINGS
SETTINGS adjustments
for joystick Feed Rate,
PULSE cutting force
(amps), Overload
protection (amps)
Cutter
Status