RSIC-SI-CRC EZ SOUND ISOLATION CLIP
PAC International, LLC. All Rights Reserved.
• (866) 774-2100 • Fax (866) 649-2710
RSIC® is a registered Trade Mark of PAC International, LLC.
PAC International, Inc. Tel: (866) 774-2100 Technical: (866) 649-2710 Web Site: www.pac-intl.com
Ceilings: RSIC-SI-CRC EZ clips installed 48” oc
Resilient Sound Isolation Clips (RSIC-SI-CRC EZ) shall be max 48 inches
on center .
Layout the RSIC-SI-CRC EZ clips according to general guidelines
represented in this installation manual.
Any additional or non standard room dimensions need to be addressed by a
professional engineer.
Carefully remove RSIC-SI-CRC EZ pre-assembled, and pre-calibrated
clips from packaging.
Be cautious to not rotate the RSIC-SI-CRC EZ clips separate from the
Upper bracket. This may change the factory calibration of RSIC-SI-CRC
EZ.
Verify the correct quantity of each RSIC-SI-CRC EZ isolator (weight /
color) is included in the shipment.
Layout the RSIC-SI-CRC EZ clips out on the floor (reflecting the ceiling
above) Ensure there are no additional items required to complete the
installation, IE: Additional blocking to support the RSIC-SI-CRC EZ clips,
or additional clips to support the drywall furring channel.
Fasten the Resilient Sound Isolation Clip (RSIC-SI-CRC EZ) to the
structure with fasteners approved for a minimum pull-out and sheer of 200
lbs. Allowing for 1/2” deflection after the gypsum board has been installed.
Using a laser level, or tape measure set the height for all of the RSIC-SI-
CRC EZ brackets at the same height
At the perimeter, the distance between the wall and first support for the
drywall shall be less than 8”
Snap the 16 Ga cold rolled channel to the RSIC-SI-CRC EZ clip. This is a
temporary connection to speed up installation.
Screw the RSIC-SI-CRC EZ clip to the CRC channel with 2 1/2” min
screws to make a permanent connection.
Wire tie the drywall furring channel to the cold rolled channel @ 24” oc or
16” oc. (24” oc for 1 or 2 layers of gyp board, 16” oc for 3 layers of gyp
board)
Optional, Field Calibrate each isolator based on the weight they will be
holding. Variances in the field may require additional adjustment to ensure
a consistent system. (see field calibration guide on page 5)
Silver = 80 Lbs
Red = 40 Lbs
Green = 30 Lbs
Blue = 20 Lbs
White = 10 Lbs
Yellow = 5 Lbs
